|
- US Shipping Only. International customers can order using a US forwarding service. (more info)
|
Click to Enlarge
|
Tilt Plumb Bob - 5/32 Inch Center Hole (SEE NOTE):
Price: $6.99 each
Status: In Stock
(4 Available)
Part #: 20-6502A
Condition: New
|
|
|
Graphite tilt plumb bob for many late-model Bally and Williams pinball games.
5/32-inch diameter center hole.
Assemble with 1/8-inch diameter non-threaded rod and accompanying tinnerman nut.
Will also fit on threaded rods (part # 12-6231 or # 12-6452) using two (2) #6-32 wing nuts to secure (one on top, and one on bottom).
NOTE: This part was originally designed by Williams to have a thumb screw to secure it to a smooth rod. The thumb screw came with this part on games up through approximately 1980. After that, the thumbscrew was eliminated and the plumb bob was then held to a threaded rod using two (2) #6-32 wing nuts, one above, and one below, the plumb bob.
If your game originally had a plumb bob with thumb screw, you can order part # 535-5029-00 instead. Part # 535-5029-00 requires a 3/32-inch non-threaded rod, part # 535-5319-02.
NOTE: No returns on Electronics - all sales final.
Ask a question about this item
Fits The Following Games: (The list below may not be complete, and it's accuracy is not guaranteed. Contact us if you have any questions.)
BALLY: Addams Family, Addams Family Gold, Attack From Mars, Cactus Canyon, Champion Pub, Creature From the Black Lagoon, Doctor Who, NBA Fastbreak, Twilight Zone, World Cup Soccer '94, more
WILLIAMS: Algar, Alien Poker, Big Guns, Black Knight, Black Knight 2000, Congo, Cosmic Gunfight, Cyclone, Earthshaker, F-14 Tomcat, Firepower II, Hurricane, Junk Yard, Medieval Madness, Millionaire, Monster Bash, No Good Gofers, Tales of the Arabian Nights, Time Fantasy, Warlok, Whirlwind, more
|
Pinball Parts
