|
- US Shipping Only. International customers can order using a US forwarding service. (more info)
|
Click to Enlarge
|
24-Pin Wide Chip Socket - DIP (Machined Pin) 1-3/16 x 11/16 Inches (SEE NOTE):
Price: $2.59 each
Status: In Stock
(42 Available)
Part #: SOC24PINMW
Condition: New
|
|
|
24-pin wide DIP chip socket. For chips with 5/8-inch width between chip legs (side-to-side).
Measures 1-3/16 inches long x 11/16 inches wide x 5/16 inches tall (30mm x 17mm x 8mm).
High-quality machined-pin style that provides maximum connection/grip between chip socket and chip legs for reliable long-term performance, and will far out-perform factory original standard low-profile non-machined pin sockets.
Fits ROM/PROM chips 2716, 2732, 2532, 9316, 9332, and 6810 RAM, more.
Replaces Williams # 5A-9004 and similar others.
Always install a chip socket when replacing a non-socketed chip on your circuit boards! A chip socket allows for quick, easy, solder-less removal and replacement for testing or repair in the future, and saves your valuable circuit board from unnecessary soldering heat that can cause damage or shorten its lifespan.
NOTE for Bally/Stern Lamp Driver Boards: Lamp driver boards in early Bally and Stern electronic solid-state (SS) games were not designed for chip sockets. The spacing for the chip legs on these boards is slightly wider than the spacing of legs on a chip socket. This was so Bally/Stern could install chips directly on the board, with the chip legs angled slightly outward, as chips come from many manufacturers (chip legs must have no angle inward/outward when installed in chip sockets). See additional images below for example.
To install a socket such as this one on one of these boards, we recommend either using individual 12-pin SIP sockets for either side of the chip, or cutting the bridging from a 24-pin DIP socket, and installing each side separately, as shown in the additional images below.
Additional Images:
Click to Enlarge
NOTE: No returns on Electronics - all sales final.
Ask a question about this item
|
Copyright © 2003-2026, Action Pinball & Amusement, LLC, All Rights Reserved.
This website and all included content including, but not limited to, text, images, wording, design, and layout, are Copyright © Action Pinball & Amusement, LLC, All Rights Reserved, and protected under the Digital Millennium Copyright Act (DMCA) and US Government Copyright law (title 17, U.S. Code, 1976 Copyright Act, Section 106). Use or distribution of any content from this website on another website or in any other manner without express written permission of Action Pinball & Amusement, LLC, is expressly forbidden and will be prosecuted under the provisions of US Government Copyright Law.
Pinball Parts
