|
- US Shipping Only. International customers can order using a US forwarding service. (more info)
|
Click to Enlarge
|
Leaf Switch Set w/ Brackets and Diode - Slingshot Bumper (2pcs) (Bally/Williams):
Price: $33.54 set
Status: In Stock
(4 Available)
Part #: SW-1A-114-120-BKT-2
Condition: New
|
|
|
Mounting bracket on 3-lug switch is reversed on this item (faces backward).
Set of 2 leaf switches riveted to 90-degree mounting brackets and connected together with jumper wires for use on slingshot bumpers/kickers in many electronic solid-state (SS) Bally and Williams pinball games (see game list below). Includes diode pre-installed on 3-lug switch.
Brackets are mounted to back (short blade side) on 3-lug switch, and front (long blade side) on 2-lug switch (see INSTALLATION NOTES below).
Replaces older switch part #s A-4834-H (2-lug switch), and B-8734-1 (3-lug switch with reversed bracket and diode- used in later games).
SWITCH MEASUREMENTS: Overall length: 3-1/16 inches. Length of long blade out from switch stack: 1-15/16 inches. Length of short blade out from switch stack: 1-3/8 inches. Contact points 1-7/32 inch out from switch stack. Switch stack body: 3/4 inches long x 3/8 wide x 3/8 high. Screw mounting holes 1/8 inch diameter, 3/8 inch center-to-center.
INSTALLATION NOTES: - Some games require one of these switches to have a mounting bracket on the REAR of the switch, rather than the front. If your game requires this, contact us when ordering, and we can reverse the mounting bracket for you (additional charge of $5.00 per switch for parts/labor will apply). Or check part #s SW-1A-114-120-BKT-1 or A-11539-1 as possible alternatives.
- Switch contacts are wired in parallel, so that activation of either switch will make the slingshot bumper kick.
- Switch using a diode (late-model games) will connect to existing wiring (green and white wires) with white wire going to lug with diodes anode (non-banded end), and green wire going to the unused lug on the switch.
NOTE: No returns on Electronics - all sales final.
Ask a question about this item
Fits The Following Games: (The list below may not be complete, and it's accuracy is not guaranteed. Contact us if you have any questions.)
BALLY: Cactus Canyon
|
Copyright © 2003-2026, Action Pinball & Amusement, LLC, All Rights Reserved.
This website and all included content including, but not limited to, text, images, wording, design, and layout, are Copyright © Action Pinball & Amusement, LLC, All Rights Reserved, and protected under the Digital Millennium Copyright Act (DMCA) and US Government Copyright law (title 17, U.S. Code, 1976 Copyright Act, Section 106). Use or distribution of any content from this website on another website or in any other manner without express written permission of Action Pinball & Amusement, LLC, is expressly forbidden and will be prosecuted under the provisions of US Government Copyright Law.
Pinball Parts
